LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> TSX Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Starting System) >> Starter Performance Test

Starter Performance Test

WARNING: This page is about a different car, the 2008 Acura TSX, 2007 Acura TSX, 2006 Acura TSX, 2005 Acura TSX, and 2004 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make a connection for this test using the thickest (gauge) wire possible (preferably the same gauge as used on the vehicle).
    NOTE: To avoid damaging the starter, never leave the battery connected for more than 10 seconds.
    Fig 1: Connecting Battery Terminal To Starter
    G05489901Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Connect the battery as shown. If the starter pinion moves out, it is working properly.
  3. Disconnect the battery terminal from the starter as shown. If the pinion retracts immediately, it is working properly.
    Fig 2: Disconnecting Battery Terminal From Starter
    G05489902Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Clamp the starter firmly in a vise.
  5. Connect the starter to the battery as shown, and confirm that the motor starts and keeps rotating.
    Fig 3: Connecting Starter To Battery
    G05489903Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. If the electric current meets the specification when the battery voltage is at 11.5 V, the starter is working properly.

    Specification: 

    Electric Current: 80 A or less 

scientia non olet · About LEMON Manuals