Driver's Switch Panel Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Take care not to scratch the trim and the panels.

Gently pull out the driver's switch panel (A) to release the hooks (B) and detach the clips. Disconnect the power mirror switch connector (C), then remove the panel.

Fig 1: Identifying Driver's Switch Panel, Power Mirror Switch Connector And Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the panel in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Push the clips and hooks into place securely.