Driver's Switch Panel Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Put on gloves to protect your hands.
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Take care not to scratch the dashboard, and related parts.

Remove the driver's switch panel (A).
- Pull out the bottom of the panel to release the clips, and pull it down to release the hooks (B).
- Disconnect the power mirror switch connector (C) and VSA OFF switch connector (D).
Fig 1: Identifying Driver's Switch Panel, Hooks And Power Mirror Switch Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the panel in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the connectors are plugged in properly.