LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> MDX >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Rear Climate Control >> Rear Mode Control Motor Test

Rear Mode Control Motor Test

NOTE: Before testing, check for HVAC DTCs (see GENERAL TROUBLESHOOTING INFORMATION ).
  1. Disconnect the 7P connector from the rear mode control motor.
    NOTE: Incorrectly applying power and ground to the rear mode control motor will damage it. Follow the instructions carefully.
  2. Connect battery power to the No. 1 terminal of the rear mode control motor, and ground the No. 5 and No. 7 terminals; the rear mode control motor should run smoothly. To avoid damaging the rear mode control motor, do not reverse power and ground. Disconnect the No. 5 or No. 7 terminals from ground; the rear mode control motor should stop at Vent (when the No. 5 terminal is disconnected) or Heat (when the No. 7 terminal is disconnected). Don't cycle the rear mode control motor for a long time.
    Fig 1: Identifying Rear Mode Control Motor
    G05487769Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. If the rear mode control motor did not run in step  2, remove it, then check the rear mode control linkage and door for smooth movement.
    • If the linkage and door move smoothly, replace the rear mode control motor (see REAR MODE CONTROL MOTOR REPLACEMENT  ).
    • If the linkage or door stick or bind, repair them as needed.
scientia non olet · About LEMON Manuals