System Links
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
- Enter this screen by connecting the SCS connector or by selecting Self Diagnosis Mode from the navigation screen main menu The message at the bottom of the screen flashes indicating the diagnostic is running Make sure you enter the anti-theft codeNOTE:
- The system cannot complete a full diagnosis unless the engine is running
- DTC 1801 can be stored when the ignition switch is in ACC (I), or press the engine start/stop button to select the ACC mode With the ignition switch is in ACC (I), or press the engine start/stop button to select the ACC mode, the AcuraLink is turned off and the audio-navigation unit loses communication and stores DTCs Therefore, there is a possibility that the system is normal even though DTC 1801 is stored Check system links with the engine running, and if it appears normal, the system is OK at this time
USA models
Canada models
- Rotate the interface dial to select the icon you want to diagnose Push in the selector to see the details of that diagnostic function
The System Links function runs automatically and displays a flashing message at the bottom of the screen reminding you to have the engine running for the test The diagnostic tests the following
- Most of the wires connecting the navigation components are shown in the block diagram
- The results from the various components shown in the block diagram
- The audio-navigation unit tests the microphone by listening to the bong sound produced by the audio-navigation unit from the speakers when the diagnostic is started This requires that the audio system be operating normally
When the diagnostic finishes, the icons turn different colors based on their test status The color definitions are shown below and can also be seen by selecting Help on the System Links screen
The indication on the screen may not change until you exit and reenter the Self-Diagnosis mode In some cases, you may have to restart the engine for the indication to change After you repair the affected component or harness, repeat this diagnostic
Each icon color is explained in the table
ICON COLORS DESCRIPTION
| Icon Colors | Description |
|---|---|
| Green | The system ran a diagnosis and the results are OK |
| Red | Errors that require replacement of hardware or harness Examples are connection error or memory diagnosis errors Troubleshoot for DTCs |
| Yellow | Errors that do not require hardware replacement, such as an open display cover, leaving the vehicle in ACC mode, or because of a missing accessory |
| White | The diagnosis is running The screen functions are locked out while the diagnosis runs |
| Gray | The system cannot automatically check this function You have to select the diagnosis item and manually do additional testing, like checking the navigation buttons in the Hard Key test When you complete the Hard Key test and return to the System Links menu, the gray icon turns green |
NOTE:
By selecting the HELP icon, you can see a description for each color