LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> CSX Base, Automatic >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front And Rear Suspension >> Wheel Bolt Replacement >> Front

Wheel Bolt Replacement: Front

  1. Remove the front hub (see KNUCKLE/HUB REPLACEMENT ).
  2. Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachments (C) or equivalent tools.
    NOTE:
    • Before installing the new wheel bolt, clean the mating surface on the bolt and the hub.
    • The illustration shows a front hub.
    Fig 1: Identifying Wheel Bolt, Hub And Hub With Hydraulic Press Attachments
    G06267697Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
    NOTE:
    • Degrease all around the wheel bolt and the threaded section of the nut.
    • Make sure the wheel bolt is installed vertically in relation to the hub disc surface.
  4. Install the wheel bolt using a hydraulic press until the wheel bolt shoulder is fully seated.
  5. Install the front hub (see KNUCKLE/HUB REPLACEMENT ).
NOTE: If you cannot tighten the wheel nut to the specified torque value when installing the wheel, replace the front hub or rear hub bearing unit as an assembly.
scientia non olet · About LEMON Manuals