Voice guidance cannot be heard, is broken up, or there is too much static
WARNING: This page is about a different car, the 2008 Acura CSX, 2007 Acura CSX, and 2006 Acura CSX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Always check that the volume setting and voice feedback are turned ON.
- Always check the connectors for poor connection or loose terminals.
- Before troubleshooting, make sure you have the navigation system 4-digit anti-theft code, then write down the audio presets.
- After troubleshooting, enter the navigation system anti-theft code, then enter the audio presets.
- Press the display unit SET-UP button.
- Check the volume setting for the navigation system.
Is it set to OFF?
YES -Set the volume to an audible level.
NO -Go to step 3.
- Check the radio operation.
Can you hear the radio?
YES -Go to step 4.
NO -Troubleshoot the audio system.
- Go into the Diagnostic Menu and use the "Navi System Link" test (see SYSTEM DIAGNOSTIC MODE
) to check the radio.
Is "Radio" icon red?
YES -Troubleshoot the audio system.
NO -Go to step 5.
- Check the voice control switch (see VOICE CONTROL SWITCH TEST
).
Is voice control switch OK?
YES -Replace the navigation unit (see NAVIGATION UNIT REMOVAL/INSTALLATION ).
NO -Replace the voice control switch unit (see Voice Control Switch Replacement ).