LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> CSX Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Automatic Transmission) >> 3rd Clutch Transmission Fluid Pressure Switch Replacement

3rd Clutch Transmission Fluid Pressure Switch Replacement

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle Make sure it is securely supported
  2. Remove the splash shield.
  3. Disconnect the 3rd clutch transmission fluid pressure switch connector, and remove the 3rd clutch transmission fluid pressure switch (A)
    Fig 1: 3rd Clutch Transmission Fluid Pressure Switch And Sealing Washer With Torque Specification
    G05990787Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install a new 3rd clutch transmission fluid pressure switch and a new sealing washer (B), and tighten the switch
  5. Make sure there is no water, oil, dust, or foreign particles inside the connector
  6. Connect the connector securely
  7. Install the splash shield
scientia non olet · About LEMON Manuals