Intermediate Shaft Disassembly

Special Tools Required 

• Support base attachment 07LAF-SM40300
• Support base 07965-SD90100
• Bearing Drive Attachment, 42 x 47 mm 07746-0010300
• Driver handle, 15 x 135L 07749-0010000

1. Remove the heat shield (A)
   Fig 1: Identifying Heat Shield With Bolts

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the outer seal (A) and the external snap ring (B) from the intermediate shaft (C)
   Fig 2: Identifying Outer Seal, External Snap Ring And Intermediate Shaft

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using the support base attachment (C), the support base (D), and a press Be careful not to damage the bearing support ring (E) on the intermediate shaft during disassembly
   Fig 3: Pressing Intermediate Shaft

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the internal snap ring (A) from the bearing support (B)
   Fig 4: Identifying Internal Snap Ring And Bearing Support

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Press the intermediate shaft bearing (A) out of the bearing support (B) using the 15 x 135L driver handle (C), the 42 x 47 mm attachment (D), the support base attachment (E), the support base (F), and a press
   Fig 5: Pressing Intermediate Shaft Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.