Rearview Mirror Replacement

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

1. Remove the roof console (see HEADLINER REMOVAL/INSTALLATION ).
2. Disconnect the connector (A), and carefully remove the bracket cover (B) by releasing the hooks (C). Take care not to scratch the cover and mirror bracket (D).
   Fig 1: Removing Bracket Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Slide the rearview mirror (A) forward to release the spring (B) by gently tapping the mirror bracket with a flat-tip screwdriver wrapped with a clean shop towel and a plastic hammer. Remove the mirror from the lug (C).
   Fig 2: Removing Mirror From Lug

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the wire cover (A) from the mirror bracket-(B) by releasing the hooks (C) in the sequence shown.
   Fig 3: Removing Wire Cover From Mirror Bracket

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Install the rearview mirror (A) by sliding it over the lug (B) until the spring contacts the lug. Gently tap the mirror bracket with a flat-tip screwdriver wrapped with a clean shop towel and a plastic hammer. Be careful not to damage the wires.
   Fig 4: Installing Rearview Mirror

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Install the wire cover (A) in the sequence shown. Take care not to damage the hooks (B).
   Fig 5: Installing Wire Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Install the bracket cover, and connect the connector, then install the roof console.