With Navigation System

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the dashboard and related parts.
Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
Do not work in a dusty or dirty place.
Discharge static electricity from your body before and during the work.
Do not touch the circuit board with your bare hands.
Do not work with dirty hands.
Be careful not to fold the flat plate cable.
Do not touch the terminal connector of the flat plate cable with your bare hands. (If you have touched it, wipe it off thoroughly.)

Remove the Audio-HVAC-Display module (see AUDIO-HVAC DISPLAY MODULE REMOVAL/INSTALLATION ).
Remove the audio unit (see AUDIO-HVAC DISPLAY PANEL REMOVAL/INSTALLATION ).
Remove the screws (A, B) securing the center vent (C) and the display unit cover (D).

Fig 1: Identifying Securing Center Vent And Display Unit Cover Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull up on the top of the display unit cover (A) slightly until the middle mounting portion (B) of the center vent (C) can be removed from under the bracket (D), then remove the center vent from the center panel (E).

Fig 2: Identifying Unit Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the center vent in the reverse order of removal.