LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> TL Type S, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission >> Reverse Lockout Solenoid Disassembly/Reassembly

Reverse Lockout Solenoid Disassembly/Reassembly

NOTE: Use fender covers to avoid damaging painted surfaces.
  1. Remove the left rear engine compartment cover (A) and the left side engine compartment cover (B).
    Fig 1: Identifying Rear Engine Compartment Cover And Left Engine Compartment Cover
    G05458518Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
  3. Disconnect the negative cable from the battery, then disconnect the positive cable.
  4. Remove the battery.
  5. Remove the air cleaner assembly (see THROTTLE BODY CLEANING ).
  6. Remove the battery base.
    Fig 2: Identifying Battery Base
    G05458519Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Carefully remove the shift cable bracket to avoid bending the shift cables (see step 17 on TRANSMISSION REMOVAL  ).
  8. Disconnect the reverse lockout solenoid connector.
  9. Remove the bolts (A), transmission harness bracket (B), and reverse lockout solenoid assembly (C).
    Fig 3: Identifying Transmission Harness Bracket And Reverse Lockout Solenoid Assembly
    G05458520Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Remove the roller (A) and select lock cam (B).
    Fig 4: Identifying Roller And Select Lock Cam
    G05458521Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Reassemble in the reverse order of removal.
  12. Clean any the dirt and oil from the sealing surface.
  13. Apply liquid gasket, P/N 08718-0001 evenly to the mating surface. Install the component within 5 minutes of applying the liquid gasket.
    NOTE:
    • If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
    • If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
  14. Install the reverse lockout solenoid assembly (A), transmission harness bracket (B), and the bolts (C).
    Fig 5: Reverse Lockout Solenoid Assembly And Transmission Harness Bracket With Torque Specifications
    G05458522Courtesy of AMERICAN HONDA MOTOR CO., INC.
  15. Connect the reverse lockout solenoid connector.
  16. Install the shift cable bracket and shift cables (see step 37 on TRANSMISSION INSTALLATION  ).
  17. Install the battery base.
  18. Install the air cleaner assembly (see THROTTLE BODY CLEANING ).
  19. Install the battery. Clean the battery posts and cable terminals. Connect the positive cable to the battery first, then connect the negative cable, and apply multipurpose grease to prevent corrosion.
  20. Install the left rear engine compartment cover and the left side engine compartment cover.
  21. Enter the anti-theft codes for the audio system and navigation system (if equipped) and set the clock.
scientia non olet · About LEMON Manuals