Paddle Shifter + (Upshift Switch) Test

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS before doing repair or service.

1. Remove the steering wheel (see STEERING WHEEL REMOVAL ).
2. Check the paddle shifter + (upshift switch) for continuity between steering wheel switch harness 20P connector terminals No. 15 and No. 7. There should be continuity while pressing the paddle shifter + (upshift switch), and no continuity when the paddle shifter + is released.
   Fig 1: Identifying Steering Wheel Switch Harness 20P Connector Terminals

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. The paddle shifter + (upshift switch) test is finished if the test result is OK.

   If the paddle shifter + works incorrectly at the 20P connector, test the paddle shifter + at the connector.

4. Remove the paddle shifter + (upshift switch) connector from its holder, and disconnect the connector.
   Fig 2: Disconnecting Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Check the paddle shifter + (upshift switch) for continuity between the paddle shifter + (upshift switch) connector terminals while pressing the paddle shifter + and when the paddle shifter + is released.

   There should be continuity while pressing the paddle shifter +, and no continuity when the paddle shifter + is released.

6. Replace the paddle shifter + (upshift switch) if the paddle shifter + works incorrectly.
7. Replace the steering wheel switch harness if the paddle shifter + is OK.