Paddle Shifter + (Upshift Switch) Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS before doing repair or service.

1. Remove the steering wheel (see STEERING WHEEL REMOVAL ).
2. Remove the steering wheel rear cover (A).
   Fig 1: Identifying Steering Wheel Rear Cover And Screw

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the paddle shifter + (upshift switch) connector from its holder, and disconnect the connector.
4. Remove the screw (B) securing the paddle shifter + (upshift switch) (C), then remove and replace the paddle shifter +.
5. Install a new paddle shifter + (upshift switch) with the screw, connect the connector, and install the connector in the holder.
6. Install the steering wheel rear cover.
7. Install the steering wheel (see STEERING WHEEL INSTALLATION ).