Intermediary Shaft Bearing Replacement

Special Tools Required 

• Bearing remover shaft set, 20 mm 07936-3710600
• Bearing remover shaft handle 07936-3710100
• Sliding hammer weight 07741-0010201
• Driver 07749-0010000
• Attachment, 37 x 40 mm 07746-0010200

1. Remove the intermediary shaft bearing from the transmission housing using the bearing remover shaft set, 20 mm, the sliding hammer weight, and the bearing remover shaft handle.
   Fig 1: Removing Intermediary Shaft Bearing From Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing until it bottoms in the transmission housing using the driver and the attachment, 37 x 40 mm.
   Fig 2: Installing Intermediary Shaft Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.

Special Tools Required 

• Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A
• Driver 07749-0010000
• Attachment, 52 x 55 mm 07746-0010400

1. Remove the intermediary shaft bearing from the torque converter housing using the adjustable bearing puller, 25-40 mm and a commercially available 3/8 "-16 slide hammer (A).
   Fig 1: Removing Intermediary Shaft Bearing From Torque Converter Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the ATF guide plate (A), then install a new bearing (B) in the housing.
   Fig 2: Identifying ATF Guide Plate And Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the bearing into the housing using the driver and the attachment, 52 x 55 mm.
   Fig 3: Installing Intermediary Shaft Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.