LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> TL Base >> Repair and Diagnosis >> Engine Mechanical >> Intake Manifold And Exhaust System >> Injector Base Removal and Installation >> Installation

Injector Base Removal and Installation: Installation

  1. Install the front injector base (A) and rear injector base (B) with new gaskets (C), and tighten the bolts/ nuts (D) in a crisscross pattern in three steps, beginning with the inner nuts.
    NOTE: The front injector base gasket is different from the rear one. Do not mix injector base gasket types.
    Fig 1: Front Injector Base And Rear Injector Base With Torque Specification
    G05457836Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Connect the knock sensor connector (A) and install the harness bracket mount bolt (B).
    Fig 2: Knock Sensor Connector And Harness Bracket Mount Bolt With Torque Specification
    G05457837Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the injectors (see INJECTOR REPLACEMENT ).
  4. Install the intake manifold (see INSTALLATION  ).
  5. Install the P/S pump and P/S hose bracket (see step 25 in CYLINDER HEAD INSTALLATION ).
  6. Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel lines will be pressurized. Repeat this three times, then check for fuel leaks.
scientia non olet · About LEMON Manuals