Control Shaft Bearing Replacement

Special Tools Required 

• Bearing remover shaft, 10 mm 07936-GE00100
• Bearing remover head, 10 mm 07936-GE00200
• Sliding hammer weight 07741-0010201
• Driver 07749-0010000
• Attachment, 22 x 24 mm 07746-0010800

1. Remove the control shaft bearing from the transmission housing using the bearing remover head (10 mm), the bearing remover shaft (10 mm), and the sliding hammer weight.
   Fig 1: Removing Control Shaft Bearing From Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the new bearing in the transmission housing using the driver and the attachment (22 x 24 mm).
   Fig 2: Pressing Bearing Into Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.