LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Power Steering System) >> Gearbox Mount Cushion Replacement

Gearbox Mount Cushion Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gearbox (see STEERING GEARBOX REMOVAL  ).
  2. Position the 34 mm socket wrench (A) on the flange part of the gearbox housing with a washer (B), a 10 x 105 mm flange bolt (C) and a 10 mm nut (D) as shown.
    Fig 1: Identifying Flange Bolt And Nut
    G05461627Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Hold the flange bolt with a wrench, and tighten the nut with another wrench. Remove the gearbox mount cushion (E).
  4. Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place it on the gearbox mounting cushion hole.
    Fig 2: Identifying Gearbox Mounting Cushion Hole
    G05461628Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Position the 34 mm socket wrench on the flange part of the gearbox housing with a washer, a flange bolt, and a nut as shown.
  6. Install the gearbox mount cushion by tightening the nut until the mount cushion edges (B) contact the gearbox flange surface.
  7. Install the steering gearbox (see STEERING GEARBOX INSTALLATION  ).
scientia non olet · About LEMON Manuals