Center Console Rear Cover Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC trim tool set SOJATP2014*

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to bend or scratch the trim and panels.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the center console rear section (see CENTER CONSOLE REAR SECTION REMOVAL/INSTALLATION ).
Open the armrest (A) and remove the screws, then remove the armrest.

Fig 1: Identifying Armrest And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the clips, then pull the console upper trim (A) up and forward to release the hooks (B).

Fig 2: Identifying Console Upper Trim And Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the console pocket (A).
1. Open the console pocket, and release the hooks (B).
2. Pull the console pocket out to release the tabs (C).
  
  Fig 3: Pulling Console Pocket
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Loosen the screws both sides.
Remove the screws, then remove the center console rear cover (A).

Fig 4: Identifying Center Console Rear Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the cover in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.