Removal and Installation: Removal
WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped). Make sure the ignition switch is OFF.
- Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
- Remove the left front door sill trim and left kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
- Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A).
- Remove the two mounting bolts and pull the fuse/ relay box away from the body.
- Disconnect the connectors and remove the under-dash fuse/relay box.NOTE: Some SRS harness connectors are spring-loaded lock type (see SPRING-LOADED LOCK CONNECTOR ).
- If replacing the fuse/relay box, carefully remove the relays by prying under the base of the relay.
NOTE:
Do not use pliers to remove the relays.