Front Brake Pad Inspection and Replacement: Inspection
WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Due to the high performance nature of the brake system on the Type-S model (4-piston caliper type), the brake disc and pads may wear faster than on the other models. Be sure to inspect the front brake disc thickness anytime the front pads are replaced.
- Raise the front of the vehicle, and support it with safety Stands in the proper locations (see LIFT AND SUPPORT POINTS ).
- Remove the front wheels. Take care not to scratch the calipers (Type-S model, 4-piston caliper type).
- Except Type-S model: Remove the brake pads.
- Check the thickness (A) of the brake pads. Do not include the thickness of the brake pad backing plate.
Brake pad thickness:
Standard:
Except Type-S model:
10.3-11.0 mm (0.41-0.43 in.)
Type-S model (4-piston caliper type):
8.8-10.0 mm (0.35-0.39 in.)
Service limit: 1.6 mm (0.06 in.)
Except Type-S model
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Type-S model (4-piston caliper type)
- If the brake pad thickness is less than the service limit, replace the brake pads as a set.
- Except Type-S model: Install the brake pads.