LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Side Impact Sensor (First) Replacement >> Installation

Side Impact Sensor (First) Replacement: Installation

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new side impact sensor (first) with TORX bolts (A), then connect the floor wire harness 2P connector (B) to the side impact sensor (first).
    Fig 1: TORX Bolts And Floor Wire Harness 2P Connector With Torque Specifications
    G05463572Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect the negative cable to the battery.
  3. Install all removed parts.
  4. After installing the side impact sensor (first), confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
scientia non olet · About LEMON Manuals