LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Front Impact Sensor Replacement >> Installation

Front Impact Sensor Replacement: Installation

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new front impact sensor with new TORX bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).
    Fig 1: Wire Harness 2P Connector And Front Impact Sensor With Torque Specifications
    G05463580Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect the driver's airbag 4P connector, the front passenger's airbag 4P connector (see GENERAL TROUBLESHOOTING INFORMATION  ), and both seat belt tensioner 4P connectors (see step 6 on DISCONNECTING SYSTEM CONNECTORS  ).
  3. Reconnect the negative cable to the battery.
  4. Install all removed parts.
  5. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
scientia non olet · About LEMON Manuals