Driver's Seat Position Sensor Replacement: Installation

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Be sure to install the harness wires so they are not pinched or interfering with other parts.
Do not turn the ignition switch ON (II), and do not connect the battery cable while installing the driver's seat position sensor. -
After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

Install the new driver's seat position sensor, then connect the driver's seat position sensor harness 2P connector to the driver's seat position sensor (A).

Fig 1: Driver's Seat Position Sensor Harness 2P Connector And Driver's Seat Position Sensor With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the driver's seat assembly (see FRONT SEAT REMOVAL/INSTALLATION ).
Reconnect the negative cable to the battery.
Check the operation of the driver's seat position sensor with the HDS (see DRIVER'S SEAT POSITION SENSOR OPERATION CHECK ).