Countershaft Bearing Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A
Driver 07749-0010000
Attachment, 78 x 80 mm 07NAD-PX40100

Remove the countershaft bearing from the torque converter housing using the adjustable bearing puller, 25-40 mm and a commercially available 3/8 "-16 slide hammer (A).

Fig 1: Removing Countershaft Bearing From Torque Converter Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the ATF guide plate (A) into the housing, then install a new bearing (B) in the direction shown.

Fig 2: Identifying ATF Guide Plate And Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the bearing (A) in the housing using the driver and the attachment, 78 x 80 mm; install the bearing outer notch-cut (B) to a depth (C) of 0-0.03 mm (0-0.001 in.) below the housing surface (D).

Fig 3: Installing Bearing In Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.