1st Clutch Hub Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Driver 07749-0010000
Driver attachment 07947-6340500
Attachment, 78 x 90 mm 07GAD-SD40101

Remove the 1st-hold clutch hub (A) from 1st gear (B) using the driver and the driver attachment and a press.

Fig 1: Removing 1st-Hold Clutch Hub From 1st Gear
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the 1st clutch hub (C) from 1st gear.
Install a new 1st clutch hub (A) over 1st gear (B), and install the 1st-hold clutch hub (C) in 1st gear.
NOTE: If 1st gear and the 1st-hold clutch hub are replaced, use 1st gear and the 1st-hold clutch hub with the same identifying letters (A or B).

Fig 2: Identifying 1st Clutch Hub, 1st Gear And 1st-Hold Clutch Hub
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the 1st-hold clutch hub (A) in 1st gear (B) using the driver and the attachment, 78 x 90 mm, and a press.

Fig 3: Installing 1st-Hold Clutch Hub In 1st Gear
Courtesy of AMERICAN HONDA MOTOR CO., INC.