LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Starting System) >> Starter Removal and Installation >> Removal

Starter Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped). Make sure the ignition switch is OFF.
  2. Remove the left side engine compartment cover (see step 3 on ENGINE REMOVAL ).
  3. Disconnect the negative cable from the battery, then disconnect the positive cable.
  4. Remove the battery and the battery tray.
  5. Remove the harness clamp (A).

    M/T 

    Fig 1: Identifying Harness Clamp And Starter Cable - M/T Model
    G05457397Courtesy of AMERICAN HONDA MOTOR CO., INC.

    A/T 

    Fig 2: Identifying Harness Clamp And Starter Cable - A/T Model
    G05457398Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Disconnect the starter cable (B) from the B terminal, then disconnect the BLK/WHT wire (C) from the S terminal.
  7. Remove the two bolts holding the starter, then remove the starter.
scientia non olet · About LEMON Manuals