LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Automatic HVAC System) >> Passenger's Air Mix Control Motor Replacement

Passenger's Air Mix Control Motor Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Remove the glove box housing (see GLOVE BOX HOUSING REMOVAL/INSTALLATION ).
  3. Remove the throttle actuator control module (see APP SENSOR REPLACEMENT ).
  4. Remove the climate control unit (see CLIMATE CONTROL UNIT REMOVAL/INSTALLATION  ).
  5. Disconnect the 10P connector (A) from the passenger's mode control motor. Remove the retainer (B) from the passenger's air mix control motor (C), then disconnect the 5P connector (D) from the passenger's air mix control motor. Remove the self-tapping screws and the passenger's air mix control motor from the heater unit.
    Fig 1: Identifying 10P Connector, Retainer, Passenger's Air Mix Control Motor And 5P Connector
    G05462491Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
scientia non olet · About LEMON Manuals