Driver's Under-dash Fuse/Relay Box (MICU) Removal/Installation: Installation

NOTE: The MICU which is part of the driver's under-dash fuse/relay box is a component of the immobilizer system. Because of this construction, the MICU must be registered when the driver's under-dash fuse/relay box is replaced, or the vehicle will not start.

Install the relays and connect the connectors to the driver's under-dash fuse/relay box, then install the driver's under-dash fuse/relay box in the reverse order of removal.
Install the removed parts in the reverse order of removal.
Connect the positive cable to the battery, then connect the negative cable to the battery.
If the driver's under-dash fuse/relay box is replaced, go to step 5. If the original driver's under-dash fuse/relay box is installed, go to step 10.
Connect the HDS to the data link connector.
Turn the ignition switch ON (II).
Select the BODY ELECTRICAL, then enter the IMMOBILIZER SETUP.
Select the REPLACE MPCS/MICU/IMOES, then select the suitable menu from the HDS indications.
After registration, confirm that the vehicle will start.
Do the steering column position memorization (see STEERING COLUMN POSITION MEMORIZATION ).
Enter the anti-theft codes for the audio system and navigation system (if equipped), and set the clock.
Confirm that all systems work properly.