DTC B1147: Left Rear Power Window Position Detect Circuit Error; DTC B1149: Right Rear Power Window Position Detect Circuit Error

NOTE:

If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
Information marked with an asterisk ( * ) applies to the right rear power window.

Clear the DTCs with the HDS.
Turn the ignition switch OFF, and then back ON (II).
Open and close the left (right)* rear power window by using the left (right)* rear power window switch manually.
Check for DTCs with the HDS.
Is DTC B1132 or B1133 (B1133 or B1134)* also indicated?

YES - Troubleshoot the indicated DTC(s) first.

NO - Go to step 5.
Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
Clear the DTCs with the HDS.
Turn the ignition switch OFF, and then back ON (II).
Open and close the left (right)* rear power window by using the left (right)* rear power window switch manually.
Check for DTCs with the HDS.
Is DTC B1147 (B1149)* indicated?

YES - Go to step 10.

NO - The system is OK at this time.
Turn the ignition switch OFF.
Substitute a known-good left (right) * rear power window switch.
Clear the DTCs with the HDS.
Turn the ignition switch OFF, and then back ON (II).
Open and close the left (right)* rear power window by using the left (right) * rear power window switch manually.
Check for DTCs with the HDS.
Is DTC B1147 (B1149)* indicated?

YES - Replace the left (right)* rear power window motor.

NO - Replace the left (right)* rear power window switch.