LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> RDX >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Input Shaft (Mainshaft) Speed Sensor Replacement

Input Shaft (Mainshaft) Speed Sensor Replacement

  1. Raise the vehicle up on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
  2. Remove the splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
  3. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor.
    Fig 1: Input Shaft (Mainshaft) Speed Sensor With Torque Specifications
    G05445102Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install a new O-ring (A) on the new input shaft (mainshaft) speed sensor (B), then install the input shaft (mainshaft) speed sensor and sensor washer (C) in the transmission housing.
  5. Check the connector for rust, dirt, or oil, then connect the connector securely.
  6. Install the splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
scientia non olet · About LEMON Manuals