DTC P145B: EVAP System Purge Line Non return Valve A Stuck Open
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see
GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch ON (II).
- Select the EVAP TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES - Intermittent failure, the system is OK at this time.
NO - Go to step 3.
- Replace non-return valve A (see NON-RETURN VALVE A REPLACEMENT ).
- Reset the PCM with the HDS.
- Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
- Select the EVAP FUNCTION TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES - Troubleshooting is complete.
NO - Check the EVAP canister purge line, then go to step 1.