SH-AWD Control Unit Initialization

Whenever the SH-AWD control unit is replaced, it must initialized.

1. With the ignition switch to LOCK (0), connect the HDS to the 16P DLC (A) behind the driver's dashboard lower cover.
   Fig 1: Locating Data Link Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Turn the ignition switch to ON (II).
3. From the mode menu, select miscellaneous test, then select neutral menu and follow the screen prompts.
4. Make sure the HDS communicates with the vehicle and the SH-AWD control unit. If it doesn't troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).