Yaw Rate: Notes
This diagnostic checks the yaw rate sensor in the control unit. This device detects when the vehicle turns, and repositions the vehicle position icon on the map screen. For more detailed information, see the yaw rate sensor theory of operation under "System Description" (see YAW RATE-LATERAL ACCELERATION SENSOR ).
- "Sensor" indicates the voltage output from the yaw rate sensor. It should indicate about 2.500 V when stopped.
- "Offset" is the reference voltage or standard within the yaw rate sensor. It also should indicate about 2.500 V when stopped.
- A "sensor" output voltage LOWER than the "Offset" voltage indicates that the vehicle is turning to the right.
- "sensor" output voltage HIGHER than the "Offset" voltage indicates that the vehicle is turning to the left.
- The yaw rate offset, and sensor should both indicate about 2.500 V when stopped. If either reads zero, or 5.000 V, replace the navigation unit (see NAVIGATION UNIT REMOVAL/INSTALLATION ).
- The yaw rate offset and sensor should be within +/-0.01 V of each other when stopped. The sensor value should change relative to the offset as the car is turned while driving. If not, replace the navigation unit (see
NAVIGATION UNIT REMOVAL/INSTALLATION ).YAW RATE SENSOR VOLTAGE SPECIFICATION (CAR STOPPED)
Normal Abnormal Offset 2.526 V Offset 2.526 V Sensor 2.516-2.536 V Sensor 2.623 V YAW RATE SENSOR VOLTAGE SPECIFICATION (CAR TURNING)Normal Abnormal Offset 2.526 V Offset 2.526 V Sensor 2.678 V (left turn) 2.478 V (right turn) Sensor 2.623 V (no change on turns) - "Sensitivity study" represents the status of the internal tuning function. At initialization, this value starts at 6 and increases to # 10 as the internal correction values become more accurate.
- The settings "CCW Cat Factor," "CW Cal Factor," and "Set" are for factory use only. THIS SHOULD NEVER BE ADJUSTED.
- For detailed analysis of the yaw rate select "tuning."