Parking Brake Reminder
Reconnect the gauge control module connectors, turn the ignition switch ON (II), and make these input tests at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If ail the input tests prove OK, replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).
CAVITY AND TEST CONDITION CHART
| Cavity | Wire | Test condition | Test: Desired result | Possible cause if desired result is not obtained |
|---|---|---|---|---|
| B10 | ORN | Ignition switch ON (II), parking brake pedal pressed | Measure the voltage to ground: There should be less than 1 V. |
|
| Ignition switch ON (II), parking brake pedal released | Measure the voltage to ground: There should be more than 5 V. |
|