LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> MDX >> Repair and Diagnosis >> Brakes >> Traction Control >> VSA (Vehicle Stability Assist) System >> Steering Angle Sensor Replacement

Steering Angle Sensor Replacement

NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.
  1. Remove the steering wheel (see STEERING WHEEL REMOVAL ).
  2. Remove the steering column covers (see COLUMN COVER REMOVAL/INSTALLATION ) and the cable reel (see CABLE REEL REPLACEMENT ).
  3. Remove the combination switch assembly (see step 9 on STEERING COLUMN REMOVAL AND INSTALLATION ).
  4. Remove the combination light switch (A) and the wiper/washer switch (B).
    Fig 1: Identifying Combination Light Switch, Wiper And Washer Switch
    G05486911Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Replace the combination switch body assembly (C).
  6. Install the combination switch in the reverse order of removal.
    NOTE:
    • Do not remove the steering angle sensor from the combination switch body.
    • When installing the cable reel, set the turn signal canceling sleeve position (see INSTALLATION ).
  7. Do the steering angle sensor center point writing (see STEERING ANGLE SENSOR CENTER POINT WRITING  ).
scientia non olet · About LEMON Manuals