ATF Cooler Replacement

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Raise the vehicle on a lift, or apply parking brake, block both rear wheels, and raise the front of the vehicle Make sure it is securely supported
Remove the ATF cooler assembly

Fig 1: ATF Cooler Assembly And Bolts With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the ATF cooler hoses (A) from the ATF cooler lines (B), then plug the hoses Replace the ATF cooler

Fig 2: Identifying ATF Cooler Hoses From ATF Cooler Lines
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If needed, replace the ATF cooler rubber mounts (A) and the collars (B)

Fig 3: Identifying ATF Cooler Rubber Mounts And Collars
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the ATF cooler, then remove the plugs from the hose
Connect the ATF cooler hoses (see ATF COOLER HOSE REPLACEMENT )
Secure the ATF cooler with the bolts
Check the ATF level (see ATF LEVEL CHECK )