LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> CSX Type-S >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Block) >> Oil Pan Removal

Oil Pan Removal

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the engine is already out of the vehicle, go to step  6
  2. Raise the vehicle on the lift
  3. Drain the engine oil (see ENGINE OIL REPLACEMENT )
  4. Remove the splash shield (see FRONT SPLASH SHIELD REPLACEMENT )
  5. Remove exhaust pipe A (see step 35 on ENGINE REMOVAL )
  6. Remove the rear warm up three way catalytic converter (rear WU-TWC) bracket
    Fig 1: Identifying Rear Warm Up Three Way Catalytic Converter (Rear WU-TWC) Bracket
    G05987031Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the crankshaft position (CKP) sensor cover (A) and the bolt (B), then disconnect the CKP sensor connector (C)
    Fig 2: Identifying Crankshaft Position Sensor Cover
    G05987032Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the torque converter cover (A) and the four bolts (B) securing the transmission
    Fig 3: Identifying Torque Converter Cover With Bolts
    G05987033Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the bolts securing the oil pan
  10. Using a flat blade screwdriver, separate the oil pan from the engine block in the places shown
    Fig 4: Identifying Oil Pan Bolts
    G05987034Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Remove the oil pan
scientia non olet · About LEMON Manuals