Front Door Speaker

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
Remove the bolt Then lift the speaker straight up to release the lower clips (A)
NOTE: If you pull the speaker out too far from the door, you will damage the lower clips

Fig 1: Identifying 2P Connector Terminal And Lower Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Bolt Specifications: 5 x 0.8 mm, 4.4 N.m (0.45 kgf m, 3.2 lbf ft
Disconnect the 2P connector (B), and remove the speaker
Measure the resistance between terminals No 1 and No 2
- With navigation, there should be 2 Ω
- Without navigation, there should be 4 Ω
If the resistance is not as specified, replace the door speaker