Trunk Pass-through Lid Lock Cylinder Replacement

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Take care not to tear or damage the seat covers

Remove the rear seat-back (see REAR SEAT REMOVAL/INSTALLATION )
Remove the screws, and detach the hooks (A), then remove the upper cover (B)

Fig 1: Identifying Upper Cover Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, and detach the hook (A), then pull out the lock cover (B), to release the hook (C)

Fig 2: Identifying Lock Cover And Hook
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the retainer clip (A), then remove the trunk pass-through lid lock cylinder (B) from the lid (C)
NOTE: Wear eye protection when doing this step

Fig 3: Identifying Retainer Clip And Trunk Pass-Through Lid Lock Cylinder
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the lock cylinder in the reverse order of removal, and make sure the trunk pass-through lid opens properly and locks securely