LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> CSX Base, K20Z1 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Exterior Lights) >> Automatic Lighting Sensor Test/Replacement

Automatic Lighting Sensor Test/Replacement

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Take care not to scratch the dashboard
  1. Remove the center speaker lid (see FRONT CENTER SPEAKER )
  2. Pry out the automatic lighting sensor (A)
    Fig 1: Identifying Automatic Lighting Sensor
    G05988949Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
  4. Measure the voltage between automatic lighting sensor 5P connector terminals No 3 and No 5
    • 3.6-3.7 V or more with the sensor out of direct sunlight
    • 3.3-3.5 V or less with the sensor in direct sunlight
  5. If the voltage is not as specified, replace the automatic lighting sensor
scientia non olet · About LEMON Manuals