LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> CSX Base, K20A3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Automatic Transmission) >> Input Shaft (Mainshaft) Speed Sensor Replacement

Input Shaft (Mainshaft) Speed Sensor Replacement

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the battery removal procedure (see BATTERY REMOVAL AND INSTALLATION )
  2. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A)
    Fig 1: Input Shaft (Mainshaft) Speed Sensor And O-Ring With Torque Specification
    G05990784Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor
  4. Check the connector for rust, dirt, or oil, then connect the connector securely
  5. Do the battery installation procedure (see BATTERY REMOVAL AND INSTALLATION )
scientia non olet · About LEMON Manuals