Rear Speaker
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear shelf (see TRIM REMOVAL/INSTALLATION - REAR SHELF AREA )
- Remove the mounting bolt, then tilt the speaker forward to release the front clips (A)NOTE: If you pull the speaker out too far from the rear bulkhead, you will damage the lower clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Bolt Specifications: 5 x 0.8 mm, 4.4 N.m (0.45 kgf m, 3.2 lbf ft
- Disconnect the 2P connector (B), and remove the rear speaker
- Measure the resistance between the terminals No 1 and No 2
- With navigation, there should be 2 Ω
- Without navigation, there should be 4 Ω
- If the resistance is not as specified, replace the rear speaker