Front Bulkhead Cover Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC trim tool set SOJATP2014*

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Take care not to scratch the front bulkhead and body.

Remove the washer reservoir cap (A), and release the hooks (B) and pins (C), then remove the right side engine compartment cover (D).

Fig 1: Removing Right Side Engine Compartment Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Release the hooks (A) and pins (B), then remove the left side engine compartment cover (C).

Fig 2: Removing Left Side Engine Compartment Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the clips (A, B), then remove the front bulkhead cover (C).

Fig 3: Identifying Front Bulkhead Cover Fastener Locations
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the front bulkhead cover in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.