Selector Control Shaft Bearing Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Bearing remover shaft, 10 mm 07936-GE00100
Bearing remover head, 10 mm 07936-GE00200
Sliding hammer weight 07741-0010201
Driver 07749-0010000
Attachment, 22 x 24 mm 07746-0010800

Remove the control shaft bearing from the transmission housing using the bearing remover head, 10 mm, the bearing remover shaft, 10 mm, and the sliding hammer weight.

Fig 1: Removing Control Shaft Bearing From Transmission Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new bearing until it bottoms in the transmission housing using the driver and the attachment, 22 x 24 mm.

Fig 2: Installing Control Shaft Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.