DTC 84: VSA Sensor Neutral Position
- Clear the DTC using the HDS (see HOW TO CLEAR DTCS ).
- Disconnect the HDS from the 16P DLC.
- Turn the ignition switch OFF, then turn it ON (II) again.
- Test-drive the vehicle.
Does the VSA indicator come on, and is DTC 84 indicated?
YES - Go to step 5.
NO - The system is OK at this time. Refer to INTERMITTENT FAILURES .
- Check for other DTCs.
Are any other DTCs indicated?
YES - Troubleshoot the appropriate DTC.
NO - Go to step 6.
- Do the VSA sensor neutral position memorization (see VSA SENSOR NEUTRAL POSITION MEMORIZATION ).
- Clear the DTC using the HDS (see HOW TO CLEAR DTCS ).
- Disconnect the HDS from the 16P DLC.
- Turn the ignition switch OFF, then turn it ON (II) again.
- Test-drive the vehicle.
Does the VSA indicator come on, and is DTC 84 indicated?
YES - Check for loose terminals or poor connections at the VSA modulator-control unit 47P connector. If connections are good, replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ), and recheck.
NO - The system is OK at this time. Refer to INTERMITTENT FAILURES .