DTC 65: Brake Fluid Level
- Check the brake fluid level.
Is the level correct?
YES - Go to step 2.
NO - Inspect the brake system for fluid leaks. If no leaks are found, check for all worn brake pads.
- Disconnect gauge control module connector B (28P) and brake fluid level switch 2P connector.
- Check for continuity between terminal No. 13 of gauge control module connector B (28P) and body ground.Fig 1: Checking Continuity Between Terminal No. 13 Of Gauge Control Module Connector B (28P) And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES - Repair short to body ground in the wire between gauge control module connector B and the brake fluid level switch.
NO - Go to step 4.
- Check the brake fluid level switch (see
PARKING BRAKE SWITCH TEST
).
Is the switch OK?
YES - Do the troubleshooting for the gauge control module (see SELF-DIAGNOSTIC FUNCTION ).
NO - Replace the brake fluid level switch.