Rearview Mirror Replacement

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

1. Using a trim tool, carefully remove the front cover (A) by releasing the hooks (B), and then disconnect the connector (C).
   Fig 1: Identifying Trim Front Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Carefully remove the bracket cover (A) by releasing the hooks (B). Take care not to scratch the cover and mirror bracket (C).
   Fig 2: Identifying Mirror Bracket Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Slide the rearview mirror (A) forward to release the spring (B) by gently tapping the mirror bracket with a flat-tip screwdriver and a plastic hammer. Remove the mirror from the lug (C).
   Fig 3: Identifying Rearview Mirror And Spring

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the cover (A) from the mirror bracket (B) by releasing the hooks (C) in the sequence shown.
   Fig 4: Identifying Mirror Bracket Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Install the rearview mirror (A) by sliding it over the lug (B) until the spring contacts the lug. Gently tap the mirror bracket with a flat-tip screwdriver and a plastic hammer. Be careful not to damage the wires.
   Fig 5: Installing Rearview Mirror To Lug

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Install the cover (A) in the sequence shown. Take care not to damage the hooks (B).
   Fig 6: Installing Mirror Bracket Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Install the bracket cover, and connect the connector, then install the headliner cap.