Moonroof Calibration
WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The moonroof calibration must be performed when any of the following events have occurred.
- The moonroof is manually moved with the battery dead or disconnected.
- The moonroof motor is replaced with a new one.
- Any component related to the moonroof replaced. -Wind deflector
- Moonroof glass
- Moonroof seal
- Moonroof glass bracket
- Moonroof cables, etc.
To calibrate the moonroof, perform the following steps
- Turn the ignition switch ON (II).
- Open the moonroof to full open position and release the open button.
- Pull and hold the moonroof OPEN switch until the moonroof glass moves slightly back to its mechanical stop and then forward again slightly.
- New Motor: 13 seconds delay before moonroof glass moves to mechanical stop.
- Other than new motor: This will take about 13 seconds. (Includes 13 seconds delay from switch activation unit moonroof glass moves to mechanical stop).
- Release the OPEN switch.
- Within 5 seconds, pull and hold the moonroof OPEN switch again.
- In about 3 seconds the moonroof glass will begin to slide closed.
- Continue to hold the open button until the glass moves to closed position, tilts up, and returns to the closed position again.
- Test the moonroof auto operation.