LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> RL >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Driver Position Memory System (DPMS) >> DTC Troubleshooting >> DTC B1805: Power Seat Control Unit Lost Communication with Gauge Control Module (VSP/NE Message); DTC B1808: Power Seat Control Unit Lost Communication with Gauge Control Module (A/T Message)

DTC B1805: Power Seat Control Unit Lost Communication with Gauge Control Module (VSP/NE Message); DTC B1808: Power Seat Control Unit Lost Communication with Gauge Control Module (A/T Message)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
  1. Clear the DTCs with the HDS.
  2. Turn the ignition switch OFF, and then back ON (II).
  3. Wait for 6 seconds or more.
  4. Check for DTCs with the HDS.

    Is DTC B1805 and/or B1808 indicated? 

    YES  - Go to step 5.

    NO  - Intermittent failure, the system is OK at this time. Check for loose or poor connections between the power seat control unit and the gauge control module.

  5. Check for DTCs with the HDS.

    Are DTCs B1011, B1060, B1205, B1408*, B1805, B1808, B2106, and B2160 also indicated? (*:'05-06 models) 

    YES  - Do the gauge control module input test (see GAUGE CONTROL MODULE REPLACEMENT ).

    NO  - Replace the power seat control unit.

scientia non olet · About LEMON Manuals